Netgear Nighthawk EX8000 Setup

The Netgear Nighthawk EX8000 setup is a Triple Band wifi repeater that is incredibly simple to use. The Nighthawk AC3000 includes a dedicated 5 GHz band that can handle rates of up to 1.7 Gbps, which you may enhance to accommodate your PCs. There are numerous ways to configure a Netgear EX8000, which are listed below:

Connect your EX8000 gadget to a WPS Wi-Fi network. The easiest way to configure your EX8000 Wi-Fi extender is via secured setup, which does not need you to log into any of your computers or provide any information.

Table of Contents

How to setup Netgear Nighthawk EX8000

Follow the instructions given below to setup your Netgear Nighthawk EX8000- AC3000:

Activate your extender and choose a cable or wifi connection to link it to your internet.
Open your preferred web browser after your PC or smartphone has connected.
Use the URL myWiFiext.net to access the login page for the extender, and enter your username and password in the appropriate fields.
On your PC, the Netgear Genie page will now display.
Then, depending on how your system is set up, you have to pick one of two possibilities.
Simply choose Save after making your selections to finish configuring your Netgear EX8000 .

Netgear Nighthawk EAX8000 setup Manually

Additionally it is also known as web browser setup, the manual method. Follow the steps below to learn how to manually configure a Netgear WiFi extender:

First, connect the Netgear extender to a plug box and turn it on.
Connect your Netgear Nighthawk extender to your router.
Link to Netgear_ext SSID by selecting the network management.
any web browser
By default, go to the mywifiext login page.
Create an account there if you don’t already have one.
After selecting next, touch the finish button.

Netgear Nighthawk EX8000 Setup via WPS

WPS (WIFI PROTECTED SETUP) is the simplest method for configuring the Netgear wifi extender. Please follow the steps outlined below:

First, turn on your extender.
Now, hold down the WPS button for a few seconds.
After that, your LED indicator will turn green, indicating that your extension and router are properly linked.
Repeat the process using the dual band range extender.
Use the same network password you’d use for your router’s network here.
You may find the default username and password in the WIFI extension instructions.
Finally, connect your wifi equipment to the enhanced Netgear_ext SSID.

Your Netgear Nighthawk EX8000 setup using the WPS technique is now complete.

Troubleshooting steps :

Follow the troubleshooting methods below to resolve difficulties faced during Netgear AC3000 Extender setup:

The Nighthawk EX8000 extender’s primary power source is properly connected.
Examine your electrical outlet to ensure that it is not damaged or shorted out.
Make use of a fast internet connection.
Check that each cable is properly attached.
Only use undamaged wires.
Place your extension inside the signal range of your router. Check your spelling in the address bar if mywifiext.net isn’t working.
Update the firmware on your extender to the latest recent version.
Return the Netgear EX8000 extender’s settings to their original levels.

How to reset Netgear Nighthawk EX8000

To reset the Netgear setup, perform these steps:
When you switch on your extension, the LED lights will become green.
It will take at least 5 minutes to stabilise the LED lights on your extension.
Find the reset button on your extender.
Now, using a comparable sized object, hold the reset button for up to 10 seconds until the LED light begins to flicker.
It will take at least 5 minutes to stabilise the LED lights on your extension.

Your Netgear wifi extender has been successfully reset.